Low Maintenance / High Traffic Floor Finish
PICTURE PERFECT® is a dazzling achievement in floor care technology. This premier high solids floor finish offers the highest initial application gloss and exceptional wear, especially in high traffic areas such as supermarkets, retail stores and large office building lobbies. With Ultra High Speed burnishing, PICTURE PERFECT® produces a deep wet look gloss, and requires a minimum of restorative maintenance to save time, labor and money!
Authorized UL ProductCode: 0580Packaging: 55 Gal. Drum; 5 Gal. Pail; 4 x 1 Gal./Case
- TypeIntegrated Fusion Polymer
- Coverage (sq. ft./gal)2500 - 3000
- pH8.2 ± 0.3
- Drying Time (minutes)30
- Specific Gravity (g/cc)1.03 ± 0.01
- Density (lbs/gal)8.6 ± 0.1
- Slip ResistantYes
- Freeze Thaw StableYes (3 cycles)
- Detergent ResistantYes
- Black Mark ResistantExcellent
- Scuff ResistantExcellent
- Resistant of SoilingExcellent
- Gloss RetentionExcellent
- Immediate Wet Look GlossOutstanding
- Shelf Life1 year minimum in original unopened container
DocumentationTechnical Data Sheet Picture Perfect TDS English GHS.pdf Safety Data Sheet PICTURE PERFECT SDS English.pdf Miscellaneous Documents Picture Perfect Brochure Miscellaneous Documents Picture Perfect (Undiluted) GHS Secondary Label 6 up.pdf
Floor Preparation: Strip old finish and wax using your preferred NCL floor stripper following label directions. For baseboards and corners, use an NCL baseboard stripper following label directions. If necessary, rinse thoroughly with clean water and allow to completely dry.
Application: Using a clean mop or applicator apply a thin uniform coat of PICTURE PERFECT® Low Maintenance / Traffic Floor Finish. Allow to dry for a minimum of 30 minutes after each coat. Do not apply more than 4 coats in a 24 hour period. Floor should be thoroughly dry before traffic is allowed in area.
High Speed Buffing and Burnishing: PICTURE PERFECT® Low Maintenance / High Traffic Floor Finish is an ideal product for use with high speed polishing or burnishing machines of 1000 rpm or higher. Prior to buffing or burnishing dust mop the floor surface using an NCL dust mop treatment. Buff or dry burnish using an NCL Aqua Magic™ buffing pad. For spray buffing, mop-on or autoscubber restoring use a preferred NCL gloss restorer.
Routine Maintenance: Dust mop using mop treated with an NCL dust mop treatment. Damp mop or clean with an automatic scrubber using your preferred NCL neutral floor cleaner following label directions.
Scrub and Recoat: When routine maintenance and buffing/burnishing no longer responds as needed, scrub and recoat using an NCL scrub and recoat cleaner following label directions.
Features & Benefits
- Combination Sealer/Finish saves product cost
- Maximum scuff and scratch resistance
- Minimum burnishing required to retain showcase appearance
- Designed for high traffic areas
KEEP OUT OF THE REACH OF CHILDREN
Prevention: Observe good industrial hygiene practices.
Response: Wash thoroughly after handling.
Storage: Store away from incompatible materials.
Disposal: Dispose of contents/container in accordance with local/regional/national/international regulations.
This product is not known to be a "Hazardous Chemical" as defined by the OSHA Hazard Communication Standard, 29 CFR 1910.1200.
Additional safety measures:
Read the entire label and SDS before using this product, and for additional first aid measures. SDS for this product is available under the Documents tab.